How To Measure Window For Shades

Download Commodity

Measuring for blinds may be somewhat daunting, but it's actually quite straightforward and easy to do. This commodity provides simple instructions for measuring both within and outside windows.

Inside mounted blinds are mounted inside the window frame for a neater look. This is the most pop method, if the window depth allows it.

1

Exist sure to measure out accurately. If the window is set in a deep recess, fitting the blind inside makes for a neat cease. But mistakes in measurements can ruin them altogether.
2

Measure for width. Mensurate the width of the recess in three places: at the superlative, at the middle, and at the bottom. Make sure yous hold both ends of the record on the inside edges of the recess. Annotation the smallest measurement, as it will be the one you lot use.

Ad
iii

Mensurate for height. Measure the height of the window recess 3 times: at the left, in the middle, and at the correct. Make certain y'all hold both ends of the tape on the inside edges of the recess. Note the longest measurement, equally it will be the i you use.

Advertising

Outside mounted blinds are mounted on the wall exterior the window frame. This is non the preferred method, merely an insufficient window depth may require this type of mounting.

one

Decide where the mount will be. Information technology should exist placed 1 ¹⁄₂ to 3 inches (3.8 to 7.6 cm) above the window.^[1]
2

Measure for height. Mensurate from the proposed location of the mount down to 2–iv inches (5.1–x.ii cm) below the bottom of the window. This actress overlap is to block out light and ensure privacy.
3

Measure out for width. For the width of whatever set up of blinds, carefully measure the width of the window and add between 2 and 4 inches on each side.

Add New Question

Question

Can I mount blinds on the wall higher up the window?

Justin Kirkman

Community Reply

Yes, you lot can. There should be a 4x8 header beam that runs to a higher place the entire length of the window.

Ask a Question

200 characters left

Include your e-mail address to get a message when this question is answered.

Submit

E'er utilize a steel tape measure for accuracy.
Always measure at least twice before recording your terminal measurement.
Always conspicuously indicate which measurement is the width and which is the acme. It'south very common for people to swap measurements if you are not careful, so always signal the width measurement first, then the height last (W x H).

Thanks for submitting a tip for review!